Bearings kit for rear Edition One SL hub and Edition One MTB

Classic® and Edition One SL Freehub body

Available for: -Shimano® HG -Shimano® Microspline -Sram® XD -Sram® XDR -Campagnolo® N3W If your hub had a different freehub body than the new one you need to replace the right end cap as well....

Pawls kit for MT5 hub

Make sure to install the spring first then the pawls.

Aivee Edition one MTB front hub endcaps

Gravity One Freehub body

Available for: -Shimano® HG -Shimano® Microspline -Sram® XD If your hub had a different freehub body than the new one you need to replace the right end cap as well.

Aivee SR5 rear hub endcaps

Pawls kit for SR2, MP2, Classic® & Edition...

Make sure to install the spring first then the pawls.

Aivee grease pot for freehub body

It has a low impact on the environment. Safety sheet available on request. 30g jar.

MX2 Freehub body

Comes with 6 pawls and 6 springs

Bearing 61706-2RS for rear Gravity One hub

61706-2RS

Aivee MT6, MP,6 Edition One HD rear hub endcaps

You cannot modify a Boost hub into non-boost. Reverse is also impossible.

Aivee MT3 front hub endcaps

Available for: 9mm QR: KIT-5023 15x100mm: KIT-5025 20x110mm: KIT-5026

EZO bearings kit for front Classic® hub...

6803-2RS EZO X2

Aivee MT6 front hub endcaps QR

Available for: 9mm QR: KIT-5023 15x100mm: KIT-5025 20x110mm: KIT-5026

Torque caps kit Classic® hub

Will fit the DT swiss centerlock nut but not the Shimano which had a smaller inner diameter.

Pawls kit for MT3 hub

Make sure to install the springs first then the pawls.

Edition One Road Freehub body

Available for: -Shimano® 11spd  -Campagnolo® -Sram XDR/XD 11/12v (in stock beginning of September) If your hub had a different freehub body than the new one you need to replace the right end cap as...