
Screw and nut kit for Lefty 50 et 60 hubs.
The nut can be tightened by screwing anti-clockwise. You need to use a Shimano cassette tool.
Available for:
16 other products in the same category:
The nut can be tightened by screwing anti-clockwise. You need to use a Shimano cassette tool.
Pair of anodized black caps 12*100mm for Classic CL hub. Please check that your hub is compatible before ordering please. You can send us your hub serial number for checking. 12mm and 15mm caps are...
Available for: 9mm QR: KIT-5023 15x100mm: KIT-5025 20x110mm: KIT-5026
Available for 6holes or Centerlock, Shimano, Sram or Microspline. It is not possible to modify a boost hub in a non-boost hub by replacing the end caps. These caps are not compatible with...
Available for: 9mm QR: KIT-5141 12x100mm: KIT-5142 15x100mm: KIT-5140
A pair of left and right caps for your Edition One Road hub. 9x100 QR Made of black anodized aluminium. compatible with stright pull and j-bend model. Not compatible with disc version.
This axle and caps are needed when you have to go from your genuine 12x100mm Edition One SL hub and you need to have QR or 15x100.
End-caps are different either if you are using a Shimano® freehub body or a Sram XD freehub body Shimano®: 10mm QR: KIT-50 12x135mm: KIT-50 12x142mm: KIT-50 Sram® XD: 10mm QR: 12x135mm: 12x142mm:
You cannot modify a Boost hub into non-boost. Reverse is also impossible.
Will fit the DT swiss centerlock nut but not the Shimano which had a smaller inner diameter.