EZO bearings kit for rear Classic® hub

MP4 freehub body

Available for Shimano 10/11V and Sram XDR/XD 11/12V Please note that if you replace your existing shimano HG freehub you need also to purchase the MP2 version and a pairs of caps compatible with...

Pawls kit for MT3 hub

Make sure to install the springs first then the pawls.

Torque caps kit Classic® hub

Will fit the DT swiss centerlock nut but not the Shimano which had a smaller inner diameter.

Aivee MT6, MP,6 Edition One HD rear hub endcaps

You cannot modify a Boost hub into non-boost. Reverse is also impossible.

Aivee MT6 front hub endcaps QR

Available for: 9mm QR: KIT-5023 15x100mm: KIT-5025 20x110mm: KIT-5026

Aivee Edition one MTB rear hub endcaps

9mm : Kit-5084 12mm : Kit-5083

EZO bearings kit for rear Edition One road hub

6903-2RS EZO X2

Aivee grease pot for freehub body

It has a low impact on the environment. Safety sheet available on request. 30g jar.

Aivee SR1, SR2, SR5 front hub endcaps

Pawls kit for MT5 hub

Make sure to install the spring first then the pawls.

Gravity One Freehub body

Available for: -Shimano® HG -Shimano® Microspline -Sram® XD If your hub had a different freehub body than the new one you need to replace the right end cap as well.

Caps for rear Edition One SL hubs & Classic®

Available for 6holes or Centerlock, Shimano, Sram or Microspline. It is not possible to modify a boost hub in a non-boost hub by replacing the end caps. These caps are not compatible with...

SR5 Freehub body

Available for: -Shimano® 11spd  -Campagnolo® If your hub had a different freehub body than the new one you need to replace the right end cap as well.

EZO bearings kit for rear MP2 hub

6902-2RS EZO X2

MT3 Freehub body

Available for: -Shimano® 8/9/10 spd MTB -Sram® XD 11/12 spd If your hub had a different freehub body than the new one you need to replace the right end cap as well. Ready to use free-hub body...

Caps for front Edition One SL centerlock...

This axle and caps are needed when you have to go from your genuine 12x100mm Edition One SL hub and you need to have QR or 15x100.