Bearing 61706-2RS for rear Gravity One hub

Aivee Edition one MTB rear hub endcaps

9mm : Kit-5084 12mm : Kit-5083

EZO bearings kit for front Classic® hub...

6803-2RS EZO X2

EZO bearings kit for rear MP2 hub

6902-2RS EZO X2

Aivee SR1, SR2, SR5 front hub endcaps

Aivee MP2, MP4, MT6, MP,6 Edition One HD...

Available for: 9mm QR: KIT-5141 12x100mm: KIT-5142 15x100mm: KIT-5140

Pawls kit for MP4, MP6 and Edition One HD hub

Make sure to install the springs first then the pawls.

Pawls kit for MT5 hub

Make sure to install the spring first then the pawls.

MT3 Freehub body

Available for: -Shimano® 8/9/10 spd MTB -Sram® XD 11/12 spd If your hub had a different freehub body than the new one you need to replace the right end cap as well. Ready to use free-hub body...

Pawls kit for SR5 hub

Make sure to install the springs first then the pawls.

Caps for rear Edition One SL hubs & Classic®

Available for 6holes or Centerlock, Shimano, Sram or Microspline. It is not possible to modify a boost hub in a non-boost hub by replacing the end caps. These caps are not compatible with...

MT6, MP6, Edition One HD Freehub body

Available for: -Shimano® 11spd Road and MTB -Shimano® Microspline -Sram® XD and XDR If your hub had a different freehub body than the new one you need to replace the right end cap as well. Ready to...

Aivee Edition one MTB front hub endcaps

Torque caps kit Classic® hub

Will fit the DT swiss centerlock nut but not the Shimano which had a smaller inner diameter.

Pawls kit for SR2, MP2, Classic® & Edition...

Make sure to install the spring first then the pawls.

Caps for front Edition One SL centerlock...

This axle and caps are needed when you have to go from your genuine 12x100mm Edition One SL hub and you need to have QR or 15x100.

Edition One MTB Freehub body

Available for: -Shimano® 11s MTB -Sram® XD 12/12s If your hub had a different freehub body than the new one you need to replace the right end cap as well. Ready to use free-hub body including...