Bearings kit for rear Edition One SL centerlock hub

MP4 freehub body

Available for Shimano 10/11V and Sram XDR/XD 11/12V Please note that if you replace your existing shimano HG freehub you need also to purchase the MP2 version and a pairs of caps compatible with...

Torque caps kit Classic® hub

Will fit the DT swiss centerlock nut but not the Shimano which had a smaller inner diameter.

Aivee SR5 rear hub endcaps

Aivee Edition one MTB front hub endcaps

Aivee MT3 front hub endcaps

Available for: 9mm QR: KIT-5023 15x100mm: KIT-5025 20x110mm: KIT-5026

Caps for front Edition One SL centerlock...

This axle and caps are needed when you have to go from your genuine 12x100mm Edition One SL hub and you need to have QR or 15x100.

EZO bearings kit for rear Edition One road hub

6903-2RS EZO X2

MX2 Freehub body

Comes with 6 pawls and 6 springs

Caps for rear Edition One SL centerlock &...

Aivee MT6, MP,6 Edition One HD rear hub endcaps

You cannot modify a Boost hub into non-boost. Reverse is also impossible.

Bearing 61706-2RS for rear Gravity One hub

61706-2RS

EZO bearings kit for rear Classic® hub

6903-2RS EZO X2

Pawls kit for MP4, MP6, MX2 and Edition One...

Make sure to install the springs first then the pawls.

Caps for rear Edition One SL hubs & Classic®

Available for 6holes or Centerlock, Shimano, Sram or Microspline. It is not possible to modify a boost hub in a non-boost hub by replacing the end caps. These caps are not compatible with...

MT3 Freehub body

Available for: -Shimano® 8/9/10 spd MTB -Sram® XD 11/12 spd If your hub had a different freehub body than the new one you need to replace the right end cap as well. Ready to use free-hub body...

Edition One Road Freehub body

Available for: -Shimano® 11spd (In stock beginning of November) -Campagnolo® -Sram XDR/XD 11/12v If your hub had a different freehub body than the new one you need to replace the right end cap as...