copy of 6903-2RS Bearing

Front Aivee hub axle

Aivee front hub axle

Pawls kit for MT5 hub

Make sure to install the spring first then the pawls.

Torque caps kit Classic® hub

Will fit the DT swiss centerlock nut but not the Shimano which had a smaller inner diameter.

Aivee MT6, MP,6 Edition One HD rear hub endcaps

You cannot modify a Boost hub into non-boost. Reverse is also impossible.

Caps for front Edition One SL centerlock...

This axle and caps are needed when you have to go from your genuine 12x100mm Edition One SL hub and you need to have QR or 15x100.

copy of 6903-2RS Bearing

6903-2RS EZO X2

Aivee MT3 front hub endcaps

Available for: 9mm QR: KIT-5023 15x100mm: KIT-5025 20x110mm: KIT-5026

MX2 Freehub body

Comes with 6 pawls and 6 springs

SR1, SR2 and MP2 Freehub body

Available for: -Shimano® 11spd MTB and 11spd Road -Shimano® Microspline -Sram® XD -Sram® XDR -Campagnolo® 11v If your hub had a different freehub body than the new one you need to replace the...

Caps for rear Edition One SL hubs & Classic®

Available for 6holes or Centerlock, Shimano, Sram or Microspline. It is not possible to modify a boost hub in a non-boost hub by replacing the end caps. These caps are not compatible with...

Aivee grease pot for freehub body

It has a low impact on the environment. Safety sheet available on request. 30g jar.

Edition One MTB Freehub body

Available for: -Shimano® 11s MTB -Sram® XD 12/12s If your hub had a different freehub body than the new one you need to replace the right end cap as well. Ready to use free-hub body including...

Pawls kit for MT3 hub

Make sure to install the springs first then the pawls.

Aivee Edition one MTB front hub endcaps

copy of 6903-2RS Bearing

6903-2RS EZO X2

Aivee Effigear hub endcaps

Set of endcaps for Aivee Effigear 142mm hub.